Fixed a bug where the tool would gouge if there is an area with a fillet of greater than 90 degrees.Fixed an issue with gouging at the front with certain turning profile roughing toolpaths.

Fixed an issue where the tool leaves material at the back of the model when limit is set to cutting edge.Fixed an issue with gouging for certain turn profile roughing toolpaths with vertical passes using a neutral holder.Fixed an issue where turn profile roughing and finishing toolpaths with Z or X limits set to contact point were not matching in terms of Z and X extents.Fixed a bug where the toolpath would gouge through the part when 'no grooving' is selected.Fixed a problem with certain turn profile roughing toolpaths that were entering a radial groove even when grooving was set to no grooving.Fixed an issue with certain inside turn profile roughing toolpaths that were violating the clearance radius.Fixed an issue with turn profile roughing toolpaths where the tool was rapiding into model within the Z confinement limits.Fixed an issue with certain turning profile roughing toolpaths with vertical passes that were gouging the front of the part.For turn profile roughing with inside turning, cycle set to horizontal passes, direction set to front to back and use canned cycles checked off, added the ability for the tool to retract to Safe Z after every cutting pass.Added the ability for inside turn profile roughing front to back toolpaths to retract to safe Z after every cutting pass.Installation WHAT’S NEW The following changes have been made in the current update (2021): This document covers all three Inventor CAM products: Autodesk® Inventor CAM™ 2021 Release Notes

Autodesk inventor cam ultimate